Novus DC80L User Manual download pdf (Page 7)

7

4.3. MODEL DC80R OPERATING INSTRUCTIONS

RTD measurement

1. Press the power switch to

turn ON the calibrator.

2. Press the INPUT / OUTPUT key

to select INPUT mode.

3. Press RTD mode key

for

selecting the RTD type.

4. Connect the RTD or Resistance

to the input connector.

5. For 3 W / 4

W mode

measurements, press the wire

mode select key and to

select the desired mode. Then

wire the signal to the

corresponding input terminal.

6. Get the reading value .

RTD Simulation

1. Press the power switch to

turn ON the calibrator.

2. Press the INPUT / OUTPUT key

to select OUTPUT mode.

3. Press RTD mode key to

select the desired RTD type.

4. Press the Increment /

decrement keys

to set the desired output value.

5. Connect the RTD or Resistance

meter to the input terminals, as

indicated in the drawing at the

right.

6. For simulating signal in 3W / 4W

modes, add the extra wires as

shown in the drawing.

7.

To change the output value,

press the increment / decrement

keys

until the

desired

value is presented on

the display. Changing to

another RTD type is

accomplished by the RTD TYPE

selection key

.

1 2 3 4 5 6 7 8 9 10 11 12 13

Comments to this Manuals

No comments